Author Topic: Drag & Drop diagram as hyperlink – Run auto layout is “sticky” and can’t be chan  (Read 122 times)

Paolo F Cantoni

  • EA Guru
  • *****
  • Posts: 5848
  • Karma: +71/-75
  • Inconsistently correct systems DON'T EXIST!
    • View Profile
When you Drag & Drop a Diagram from the browser onto another diagram (as a Hyperlink), the "[ ] Run auto layout" is sticky and on my machine is set to true and disabled - so I can't change it!

VERY inconvenient!

Reported,
Paolo
Inconsistently correct systems DON'T EXIST!
... Therefore, aim for consistency; in the expectation of achieving correctness....
-Semantica-
Helsinki Principle Rules!

Glassboy

  • EA User
  • **
  • Posts: 880
  • Karma: +52/-54
    • View Profile
When you Drag & Drop a Diagram from the browser onto another diagram (as a Hyperlink), the "[ ] Run auto layout" is sticky and on my machine is set to true and disabled - so I can't change it!

I feel like this happens somewhere else too.  Can't quite remember where.

Paolo F Cantoni

  • EA Guru
  • *****
  • Posts: 5848
  • Karma: +71/-75
  • Inconsistently correct systems DON'T EXIST!
    • View Profile
Apparently, I wasn't the first to report it.

There is a workaround:

Currently the "Run Auto Layout" option will only be active if you have the "Navigation Cell" option selected, however, the auto layout still applied when using other options (such as dropping a hyperlink). To avoid the auto layout, select "Navigation Cell", then untick "Run Auto Layout", then select the option to drop the hyperlink.

Paolo
Inconsistently correct systems DON'T EXIST!
... Therefore, aim for consistency; in the expectation of achieving correctness....
-Semantica-
Helsinki Principle Rules!