Sparx Systems Forum

Discussion => General Board => Topic started by: anderspe on December 11, 2017, 08:38:15 pm

Title: Show tagged value?
Post by: anderspe on December 11, 2017, 08:38:15 pm
I want to show a specific Tagged value for a specific type of connector in a diagram! Any advice?

Regards
Anders
Title: Re: Show tagged value?
Post by: Geert Bellekens on December 11, 2017, 08:45:42 pm
Anders,

I believe you can do that using a shapescript, but I've never don't that for a connector myself, so I can't really give you any further advice.

Geert
Title: Re: Show tagged value?
Post by: PeterHeintz on December 11, 2017, 09:03:49 pm
Yes, you can use a shapescript.

This below is one example I use to show my TAG "qualitativeFrequency":

label middlebottomlabel {
   print("->#TAG:qualitativeFrequency#");
}