Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - slaza

Pages: [1]
1
General Board / Re: How to report on elements contained on a diagram
« on: January 24, 2018, 12:06:45 am »
Thank you! That is the switch I was looking for amongst the diagram properties!!!!

If it is not switched on, diagram elements are not be reported even if I include them in the template. It works like a charm now!

Thank you again,

Sandor

2
General Board / Re: How to report on elements contained on a diagram
« on: January 23, 2018, 10:48:40 pm »
Thank you, for your answer! I considered scripting, but I hoped that there is a checkbox in the document template somewhere that I can check to get the result I need. If there is none, I might need to fall back to scripting...  ;)

3
General Board / How to report on elements contained on a diagram
« on: January 23, 2018, 10:13:14 pm »
Dear All,

I am sure there is an easy way of doing it, but I couldn't find it... I created a diagram with a number of elements on it. These elements are located in a different package, not in the same as the diagram.

I would like to make a report that lists the name and the notes of the elements included in the diagram. (The package that contains the elements contains 600+ elements, I don't want to see all of them. I only want to see the ones that are on my diagram.)

Thank you for your help,

Sandor

4
Dear All,

When I add a new connection to a diagram, it automatically shows up in all other diagrams. I need to switch off visibility manually for each and every new connector.

Is there any way to set the default visibility of a connector to show only on the current diagram, and I can switch visibility on if I wanted to anywhere else?

(I am sure that I am not the first person to ask this, but I just can't find the answer...)


Pages: [1]