Sparx Systems Forum

Enterprise Architect => General Board => Topic started by: michielper on March 22, 2018, 12:09:54 am

Title: specify maximum size of a diagram in a report
Post by: michielper on March 22, 2018, 12:09:54 am
I have noticed that when generating reports, diagrams are included at the maximum size that fits on the page. With complex diagrams this is desirable, but with very simple diagrams, consisting of only a few elements, their size on the page makes the document look like a children's book :-). So is there a way to have diagrams printed smaller than their max size on a page? Perhaps limiting the enlargement factor?
Title: Re: specify maximum size of a diagram in a report
Post by: steen.jensen on March 22, 2018, 02:57:38 am
In Diagram properties, Page Setup, Advanced you can select page with or any scale
Title: Re: specify maximum size of a diagram in a report
Post by: michielper on March 23, 2018, 01:29:16 am
In Diagram properties, Page Setup, Advanced you can select page with or any scale

But I do not see how to limit the size to less than one page.
Title: Re: specify maximum size of a diagram in a report
Post by: qwerty on March 23, 2018, 08:13:47 am
But I do not see how to limit the size to less than one page.

Less than one is zero or a negative number.

q.
Title: Re: specify maximum size of a diagram in a report
Post by: Eve on March 23, 2018, 08:57:59 am
But I do not see how to limit the size to less than one page.
I believe the only option here is for integer numbers. You can't specify that it should use .5 or 1/3 of a page.