Author Topic: Allow "exact" copy of last selected arc on diagram [Alt+F3]?  (Read 1036 times)

Paolo F Cantoni

  • EA Guru
  • *****
  • Posts: 6755
  • Karma: +140/-102
  • Inconsistently correct systems DON'T EXIST!
    • View Profile
Many of us are familiar with the [F3] Functionality which allows you to draw another arc with the same default metatype information.  However, it is often very useful to be able to set up an arc and then draw an "exact" copy of the in-situ, selected, arc (other than, of course, the end-points).  I note that the [ALT+F3] key is available (not mapped by default) for this purpose.

Thoughts?
Paolo
Inconsistently correct systems DON'T EXIST!
... Therefore, aim for consistency; in the expectation of achieving correctness....
-Semantica-
Helsinki Principle Rules!

qwerty

  • EA Guru
  • *****
  • Posts: 10460
  • Karma: +230/-187
  • I'm no guru at all
    • View Profile
Re: Allow "exact" copy of last selected arc on diagram [Alt+F3]?
« Reply #1 on: May 20, 2019, 07:06:57 pm »
Sounds usefull and pretty easy to implement.

So chances are good we'll never see it implemented :-/

q.

Paolo F Cantoni

  • EA Guru
  • *****
  • Posts: 6755
  • Karma: +140/-102
  • Inconsistently correct systems DON'T EXIST!
    • View Profile
Re: Allow "exact" copy of last selected arc on diagram [Alt+F3]?
« Reply #2 on: May 21, 2019, 10:00:54 am »
Sounds usefull and pretty easy to implement.

So chances are good we'll never see it implemented :-/

q.
Reported, Anyway...
Paolo
Inconsistently correct systems DON'T EXIST!
... Therefore, aim for consistency; in the expectation of achieving correctness....
-Semantica-
Helsinki Principle Rules!